Osmo Polymer Composite Maintenance Oil

Osmo Polymer Composite Maintenance Oil 030 is a clear satin oil that penetrates the substrate and forms a protective barrier. Through impregnation the surface area is protected from dirt, oil and grease whilst also becoming water repellent.

Please note:

• Oils enhance the natural colour of a substrate and produce a permanent wet effect appearance
• Trial application is recommended
• White or very light coloured surfaces can appear to be slightly yellowed by the oil
• Non-absorbent surfaces, such as glass, glazed tiles or plastics cannot be treated
• The impregnation of the oil could influence the slip resistance of the original surface

Ensure the project area is sound, clean, dry and free from dust, frost and debris.

• Remove any loose debris from the project area with a suitable cleaning instrument, such as a stiff bristled brush
• Ensure the project area is weathered by abrading the surface to aid with absorption
• It is recommended to clean the project area with Osmo Polymer Composite Cleaner (8021)
• Osmo Polymer Composite Maintenance Oil is ready to use with no need for dilution
• Rinse the project area thoroughly with clean water and allow to dry

Always perform a test area to judge suitability and the final finish. Also, for the best results, please follow the manufacture's instructions

• Apply with the use of a Osmo Floor Brush or Osmo Soft Tip Brush
• Osmo Polymer Composite Maintenance Oil needs to be applied very thinly to aid absorption and needs to absorbed into the surface
• Ensure there is no residue left on the surface or within the grooves
• If there is any pooling of residue then use a dry brush to remove any excess oil
• Ensure good ventilation to the project area to aid with drying

Excess oil can be very slow drying and will produce a glossy layer with poor adhesion to the substrate

This is best applied thinly using a Osmo Floor Brush or Osmo Soft Tip Brush, removing any excess from the surface using a clean Woodleys Microfiber Cloth.