Craig and Rose Artisan Concrete Effect

A water based interior paint used to create the effect of textured concrete to walls and ceilings. Suitable for elevating feature walls and producing a unique finish enabling the Artisan Concrete effect to create a minimal style and compliment a neutrally toned space

To accomplish the best results the surface needs to be clean, structurally stable and free of dirt, dust and surface impurities

• Remove all loose and defective paint by either using a paint scraper, paint stripper or sanding down the project area
• Special care should be taken if removing pre 1960s paint as this could contain harmful levels of lead
• Repair any defects such as cracks or holes with a suitable filler to produce a surface free of imperfections
• If necessary, sand the project area to produce a flat smooth surface
• If the project area shows signs of grease or oil, then wash with a suitable detergent and allow to dry thoroughly
• If using two or more tins from different batches, then blend the paint together in a large container to ensure a consistent hue and tone of colour
• Mask off the project area to protect the adjoining surfaces
• If Craig And Rose Artisan Concrete Effect is being applied onto either fresh plaster or a porous surface, then prime the area with a suitable primer, such as Craig And Rose 1829 All Purpose Undercoat

Always do a test area before starting any project to assess the suitability of the product and the finish.

Use only in well ventilated areas with a room temperature that will exceed 10ºC during the drying period.

• Practice the application technique on a large area beforehand, such as cardboard or a spare piece of board or wood
• It is advisable to work in small sections on the project area
• Initially, it is best to cut in around the edges with a paint brush
• Smooth the surface with a steel trowel in broad, sweeping strokes with the trowel at a 60° to 80° angle and ensure the trowel blade remains clean
• This process will need repeating over the entire project area to create a consistent coverage
• The standard procedure is to apply 3 coats following the above procedure, allowing a minimum of 4 hours drying time between coats. However, if the depth and appearance are to be increased then further coats can be applied
• Use a 600 grit sandpaper to apply a light polish once the final coat has dried but within 24 hours of the application
• It is optional, though advisable, to apply a further coating of Craig And Rose 1829 Furniture And Effect Wax or a clear varnish to add an extra layer of protection to the concrete texture

Do not apply to highly to highly absorbent surfaces

Cleaning

The treated surface can be gently cleaned with a damp cloth and a mild detergent. Avoid forceful scrubbing .